Generally speaking, the rotation power required by the scraper suction machine is very small, so there is basically no problem of rotation power.
From the actual operation, the reasons why the scraper and suction sludge machine cannot move can be basically summarized as follows.
First, the mud discharge of the sedimentation tank is not timely enough, and too much mud is collected at the bottom of the tank. The amount of mud scraped by the scraper blade increases, resulting in an increase in the actual load of the scraper, which is manifested as an increase in the torque of the scraper shaft of the scraper. When the torque does not exceed the maximum torque that the scraper can provide and the strength of the shaft is sufficient, the scraper can still operate; when it exceeds the maximum torque that the scraper can provide, the motor cannot rotate, and then the motor trips due to overheating protection or over-torque protection device;
Second, during the rotation of the scraper and suction sludge machine, foreign objects get stuck, causing it to stop operating;
Third, the scraper and suction sludge machine has structural failures, such as corrosion and deformation caused by insufficient strength.
Fourth, the quality of the scraper and suction machine is not up to standard and it is a defective product. Please contact the manufacturer in time for processing.
The above is the analysis of the reasons why the scraper and suction sludge machine cannot move. Of course, there may be other possible man-made reasons, which will not be further explained here.
https://www.wchjdaf.com/
